WaveSense Presto Spécifications télécharger pdf (Page 21)

38 39

Setting Alarms

CHAPTER

There are 6 alarms you can set to remind you when to test

your glucose levels.

When alarms are activated:

[1] If an alarm is set and the AgaMatrix Presto Meter is deacti-

vated, the alarm will activate the meter. “AL1” thru “AL6” (de-

pending which alarm is set) is displayed. The display backlight

flashes, and the meter will beep repeatedly for 15 seconds.

[2] You can turn the alarm OFF by pressing any button.

[3] The alarms will not appear during Menu and Test Modes.

If an alarm is set to sound or flash while using these modes, it

will alarm after the meter is deactivated.

CAUTION: Follow your healthcare professional’s

recommendations on when and how often to test your

glucose.

[1] Enter MENU Mode: When your meter is deactivated,

press and hold any button for 2 seconds to enter

the MENU mode.

[2] Enter Alarm Option: The MEM symbol

appears. Press the RIGHT or LEFT arrow buttons

until the alarm you want to set is displayed (AL1

to AL6). If this is your first time setting an alarm, use AL1. Press

CENTER to select an alarm to set.

[3] Turning Alarms ON or OFF: Press the

RIGHT or LEFT arrow buttons to enable (ON) or

disable (OFF) the alarm. The default setting is

OFF. Confirm your selection by pressing CENTER

button. Your selections will be highlighted by a

blinking symbol.

[4] Setting Alarm Times: You can now set the

alarm time. First, set the flashing numbers (hour)

with the RIGHT or LEFT arrow buttons. Acceler-

ated change is possible by holding down the

arrow buttons.

Press CENTER to confirm and to move on to set

the minute.

Set (minute) with the RIGHT or LEFT arrow buttons.

Press the CENTER button to confirm the alarm

time and to move on to set the alarm volume.

[5] Setting Alarm Volumes: There are three

volume options. A silent alarm will only flash the

meter’s screen. The default setting is “high”. Select

your preferred setting with the RIGHT or LEFT

arrow buttons. Confirm by pressing the CENTER

button. This will bring you back to MENU Mode.

Note: The volume of an alarm will be affected by the meter’s

volume setting, which can be changed in the meter’s settings

(SET) option. If your meter is set to silent mode, then the alarm

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

WaveSense Presto Spécifications Page 21

Commentaires sur ces manuels